Care and Cleaning Guide

CARE & CLEANING INSTRUCTIONS-Continued
CARE FOR FINE KALLISTA
®
FURNITURE
Wood Finishes
Do not use silicone waxes, lemon oil, or other oily polishes. Your furniture has a protective
lacquer finish that most likely will not require any care other than dusting. However, on highly
used surfaces we recommend applying a quality paste wax (such as Minwax
®
Finishing Wax)
which should be used on a regular basis to provide additional protection from scratches and
spills. Minwax
®
Finishing Wax is available at most home improvement stores. How often you
apply the wax depends on how much wear the furniture receives. New furniture should be
waxed after receipt.
Before applying the wax, your furniture should always be clean. For food type spills use a cloth
or sponge which has been dampened in a mild, soapy water (without ammonia). For oily type
smudges and build-up, a cloth dampened with Murphy
®
Oil Soap will suffice. Remember to
follow the manufacturers' directions when using a cleaner of this type. Dry the piece thoroughly
with a clean, soft cloth. Apply a thin film of wax to the surface, working a small area at one
time. Always rub in the same direction as the wood grain, then buff with a soft, dry cloth.
Between waxing, your wood furniture requires dusting. For a surface that has been paste waxed
use a moist, lint free cloth, and dry immediately with another soft cloth. A pre-treated dusting
cloth that will attract dust without scratching the finish can also be used. When dusting a
surface that has not been paste waxed we suggest using a cleaning polish such as Endust
®
that
does not contain silicon. Silicon can damage the lacquers and make future refinishing very
difficult. Lemon oil and other oil based polishes should also be avoided, since they attract dust
and grit, and cause a hazy film on the finish. When caring for colored lacquers, leather,
Coromandel and Gesso type finishes, follow the same procedure as used for wood finishes.
Painted Finishes
Textured and brushed-painted finishes that have an eggshell sheen lacquer should not be
waxed or polished, as they will acquire an undesirable higher sheen. For cleaning, use mild,
soapy water, and then dry the surface immediately with a clean, soft cloth.
Other Tips for Preserving Furniture
Spills should never be wiped; they should be blotted immediately. If water stands on the surface
there is the possibility that it will cause white marks in the lacquer finish. You can remove these
blemishes by heating the area with a hair dryer and applying Endust
®
while the surface is still
warm. Follow by buffing with a soft cloth and re-apply paste wax if needed. If perfume or nail
polish remover is spilled, do not wipe or blot it. The lacquer that has been softened by the
chemicals, should return to normal when the liquid has totally evaporated. Allow the area to
dry, rub it with a fine automotive polishing compound, and then apply a fresh coat of wax. If
candle wax drops on your wood finished surface, hold an ice cube to the wax to harden it. Blot
up the water, and use a dull plastic spatula to remove the wax without touching the wood.
Gently scrape away any remaining wax, and rub the area with furniture wax to replace the
protective coating.
Wood is a natural product. Sun bleaching will occur when wood furniture is exposed to sunlight.
This will cause darker finishes to lighten and sometimes cause lighter finishes to darken. For this
reason, try to avoid placing furniture in direct sunlight and rearrange accessories from time to
time to prevent spot bleaching. Some bleaching will occur under both incandescent and
fluorescent lighting. Arrange your furniture so that it does not sit near heat registers, air-
conditioning units or radiators. It is important to keep the home or office in which your furniture
is placed properly humidified. Lack of humidity (usually in winter months or in dry climates) can
cause certain veneers to check and joints to work.