Care and Cleaning Guide

CARE & CLEANING INSTRUCTIONS-Continued
CARE OF ACRYLIC BATH WITH AIRJETS
Cleaning Your Acrylic Bath With Airjets
Do not use powdered cleaners unless the cleaner is fully dissolved in water. Solid substances
could block the airjets.
Do not use full strength bleach or ammonia cleaning solutions. Chemically active cleaning
solutions can damage the bath surface.
Do not use abrasive cleansers or solvents on acrylic surfaces. Abrasive cleaners and solvents
can damage the bath surface.
Wipe out your acrylic bath with a soft cloth after each use.
Avoid detergents, disinfectants, or cleaning products in aerosol cans.
If the surface becomes excessively dirty, use a general purpose cleaner such as:
• Formula 409
®
All Purpose Cleaner
• Gel Gloss
®
(Bath and Shower only)
• Scrub Free
®
Mildew Stain Remover
• Mr. Clean
®
Lemon Fresh
• Cinch
®
• Glass Plus
®
• Fantastik
®
All Purpose
NOTE: To restore dull or scratched units, apply white automotive polishing compound with a
clean rag. Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white
automotive paste wax. Do not wax areas where you walk or stand.
Cleaning your User Keypad and Remote Control
Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes
dirty, use a non-abrasive soap and warm water to clean.
Maintaining the Airjets
If cleaning the airjets is required due to hard water deposits, use a small between-the-teeth
dental brush and white vinegar. Dip the brush in the vinegar, brush the hole, rinse the brush in
clean water, and then use the wet rinsed brush to rinse the hole.
Fill the bath with water to the top row of airjets. Drain the bath and press the purge button.
Flushing your Airbath System
Flush your whirlpool system twice a month or more, depending upon usage. Use the following
sequence:
1. Fill bath with water one inch above the top of all airjets.
2. While bath is filling, carefully add 1 cup of bleach to the water.
3. Let sit for 10–15 minutes.
4. Drain the water, run the purge cycle and rinse any debris from the bath.
5. Clean bath surfaces as needed with recommended cleaners.
6. Dry the bath with a clean, soft towel.