Installation Sheet

ManualsBrandsKallista ManualsBathroom FaucetsOne 1.2 GPM Wall Mounted Widespread Bathroom Faucet with Cross Handles

INSTALLATION INSTRUCTIONS

Wall-Mounted Basin Set

1072016_2_C

1 of 6

Questions? Problems? For additional assistance, please contact KALLISTA’s Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.

P24410-CR

P24411-CR

P24410-LV

P24411-LV

Summary of content (6 pages)

PAGE 1
Wall-Mounted Basin Set INSTALLATION INSTRUCTIONS 1072016_2_C 1 of 6 P24410-CR P24410-LV P24411-CR P24411-LV Questions? Problems? For additional assistance, please contact KALLISTA’s Customer Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
PAGE 2
Wall-Mounted Basin Set INSTALLATION INSTRUCTIONS Thank You For Choosing KALLISTA We appreciate your commitment to KALLISTA quality products. Please take a moment to review this manual before you install your KALLISTA product. If you encounter any installation or performance problems, please do not hesitate to contact us at the phone number listed at the bottom of the page. Tools Phillips Screwdriver Hex Wrench Important Information Shut off the main water supply.
PAGE 3
Wall-Mounted Basin Set INSTALLATION INSTRUCTIONS Installation Faucet Outlet Port Spout Shank Gasket Flange Spout Escutcheon O-Ring Screws Spout Set Screw Install the Spout IMPORTANT! Use care when installing the spout to avoid scratching the finish. Insert the gasket into the back of the spout escutcheon. Confirm that the O-ring is inside the escutcheon. Carefully slide the spout escutcheon onto the spout about halfway. Thread the spout into the spout shank until it is snug.
PAGE 4
Wall-Mounted Basin Set INSTALLATION INSTRUCTIONS Installation Install the Handle Assemblies Valve Stem Gasket Wear Washer Escutcheon Adapter Spline Adapter Escutcheon Support Stem Extension Handle Assembly Unscrew the escutcheon support from the handle assembly. Remove the two screws connecting the escutcheon adapter and escutcheon support and separate the parts. Note: Be sure to retain the wear washer when removing the screws. Replace before installing handle assembly.
PAGE 5
Wall-Mounted Basin Set INSTALLATION INSTRUCTIONS Installation Install the Drain Disassemble the stopper and flange from the drain body. Apply a small bead of putty or sealant to the bottom of the flange. Insert the flange into the drain opening. Ensure the gasket is inside the flange. From the underside of the lavatory thread the drain body onto the flange assembly. Tighten firmly. Install the stopper and tighten firmly.
PAGE 6
Wall-Mounted Basin Set INSTALLATION INSTRUCTIONS Installation Spout Spout Aerator Aerator Key Complete the Installation Connect the tailpiece and P-trap (not supplied). Ensure that all connections are watertight. Remove the aerator by turning it counterclockwise. Use the supplied key if required for removal of your aerator. Open the drain. Turn on the main water supply and check for leaks. Repair as needed.