Installation & Assembly

ManualsBrandsKallista ManualsBathBellis® Double Handle Deck Mounted Roman Tub Faucet

INSTALLATION INSTRUCTIONS

Deck-Mounted Bath Set

1144944_2_A

1 of 5

Questions? Problems? For additional assistance, please contact KALLISTA’s Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.

P24603-CR

P24603-LV

Summary of content (5 pages)

PAGE 1
Deck-Mounted Bath Set INSTALLATION INSTRUCTIONS P24603-CR 1144944_2_A 1 of 5 P24603-LV Questions? Problems? For additional assistance, please contact KALLISTA’s Customer Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
PAGE 2
Deck-Mounted Bath Set INSTALLATION INSTRUCTIONS Thank You For Choosing KALLISTA We appreciate your commitment to KALLISTA quality products. Please take a moment to review this manual before you install your KALLISTA product. If you encounter any installation or performance problems, please do not hesitate to contact us at the phone number listed at the bottom of the page.
PAGE 3
Deck-Mounted Bath Set INSTALLATION INSTRUCTIONS 2. Prepare for Spout Installation Remove the plaster guard from the spout supply tube. Cut off the spout supply tube 1-1/2” (3.8 cm) above the rim, finished deck, or tile. Remove all burrs from the supply tube to prevent damage to the O-ring seal. 1-1/2” (3.8 cm) Tile Rough Deck 3. Install the sleeve CAUTION: Risk of product damage. Use care when installing the spout assembly to prevent damage to the O-ring seal.
PAGE 4
Deck-Mounted Bath Set INSTALLATION INSTRUCTIONS 4. Install the Spout Remove the setscrew from the back of the spout assembly. Install an O-ring in the bottom of the spout. Position the spout on the sleeve, and carefully press down until the spout contacts the finished deck. Align the spout as desired and tighten the setscrew. Install the plug into the setscrew. If desired, apply a bead of silicone sealant around the base of the spout according to the manufacturer’s instructions.
PAGE 5
Deck-Mounted Bath Set INSTALLATION INSTRUCTIONS Install the handles (cont’d) Repeat the procedure with the other handle assembly. If desired, apply a bead of silicone sealant around the base of the handle assemblies according to the manufacturer’s instructions. 6. Complete installation Ensure that both faucet handles are turned off (cold = fully counterclockwise; hot = fully clockwise). Turn on the main water supply, and check for leaks. Repair as required.