Installation & Assembly

INSTALLATION INSTRUCTIONS
Deck-Mounted Bath Set
1144944_2_A
4 of 5
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
INSTALL THE SPOUT4.
Sleeve
Spout
O-ring
Setscrew
Plug
Remove the setscrew from the back of the spout assembly. 
Install an O-ring in the bottom of the spout. 
Position the spout on the sleeve, and carefully press down until the spout 
contacts the nished deck.
Align the spout as desired and tighten the setscrew. 
Install the plug into the setscrew. 
If desired, apply a bead of silicone sealant around the base of the spout 
according to the manufacturer’s instructions.

INSTALL THE HANDLES5.
Handle Assembly
Screw
Sleeve
Stem Extension
O-ring
NOTE: The hardware pack contains two different length stem
extensions and screws. Choose the stem extension and screw
combination that works for your installation.
Make sure the valves are closed (cold = fully counterclockwise; 
hot = fully clockwise).
Install a stem extension on one of the valve stems. 
Remove the sleeve from a handle assembly. 
With the handle oriented correctly, place a handle assembly over 
the stem extension and verify correct handle alignment.
NOTE: The handle alignment can be adjusted by removing the
handle assembly and stem extension. Rotate the stem extension
one tooth and replace. Replace the handle assembly and check
the alignment. Repeat this procedure until the handle alignment is
satisfactory.
Remove the handle assembly and secure the stem extension to 
the valve with the screw.
Re-install the sleeve into the handle assembly. 
With the handle oriented correctly, hold the handle with one 
hand and thread the handle assembly into the valve assembly
with the other hand.