Manualshelf

Installation Sheet

ManualsBrandsKallista ManualsBathroom HardwarePinna Paletta Wall Mounted Spring Bar Toilet Paper Holder
12
1/4" 5/16"1/8"
2
For All Installations:
Loosen the setscrew and remove the
wall plate from the accessory.
X
P24931, P24941: 24" (610 mm)
P24933, P24943: 18" (457 mm)
P24935, P24945: 12" (305 mm)
P24939, P24949:
6-7/8" (175 mm)
1
Two-Post Accessories:
Verify “X” against the measurements
of your product model.
6"
(152 mm)
8" (203 mm) –
12" (305 mm)
Recommended Tissue Holder
Location
Important Information
These products should be located and
mounted to a wall stud. While it is
possible to mount them to any surface,
a stud mounted product will yield the
best results.
CAUTION: Risk of personal
injury.
Do not install where the product might
be used as a grab or support bar.
Record your model number below
for future reference:
5
For All Accessories:
Position the accessory onto the wall
plate(s). Tighten the setscrew(s).
Ceramic Tile:
Drill 1/4" holes. Insert ceramic anchors.
Secure the wall plate(s).
1
2
3
4
Drywall Between Studs:
Drill 5/16" holes. Use the provided pin
to install the drywall anchors. Secure
the wall plate(s).
4
Drywall Into Studs:
Drill 1/8" holes. Secure the wall
plate(s).
3
Single-Post Accessories:
Position the wall plate and mark the
holes. Verify plumb.
1266043-2-A

Summary of content (2 pages)