Installation Guide Accessories P34401, P34402, P34403, P34406, P34407, P34408, P34410 Français, page “Français-1” Español, página “Español-1” 1078044-2-A
Thank You For Choosing Kallista Thank you for choosing Kallista. Please take a few minutes to review this manual before you start installation. If you encounter any installation or performance problems, please don’t hesitate to contact us from within the USA or Canada at 1-888-4-KALLISTA (1-888-452-5547). Tools and Materials Level Tape Measure Assorted Screwdrivers Pencil Plus: • 5/16" Drill Bit • Silicone Sealant • Caulk Gun Drill 5/64" Before You Begin CAUTION: Risk of personal injury.
16" (406 mm) 2-1/4" (57 mm) P34403-00 2-1/4" (57 mm) 16" (406 mm) 2-1/4" (57 mm) 3-1/2" (89 mm) 3-1/4" (83 mm) P34410-00 5-1/2" (140 mm) 26-1/4" (667 mm) 2-1/4" (57 mm) P34401-00 20-1/4" (457 mm) 3-1/2" (89 mm) P34407-00 P34402-00 1-5/8" (41 mm) 3-1/2" (89 mm) 2-1/4" (57 mm) 3-3/8" (86 mm) 2-1/4" (57 mm) P34406-00 5-5/16" (135 mm) 1-1/8" (29 mm) 2-1/4" (57 mm) P34408-00 1-1/2" (38 mm) 11/16" (17 mm) Roughing-In Kallista 3 1078044-2-A
Wall Bracket Hole Locations Locate the Wall Plate Centerpoint Wall Bracket Level For multiple-post layout only. Holes 1. Prepare the Site — Anchor Holes For Multiple-Post Accessories NOTE: Take into account the length of the accessory components to determine the required distance between the post center points. Consult the ″Roughing-In″ section for dimensions. Mark the vertical and horizontal centerlines for each post. Use a level to ensure that all center points are level.
Install the Wall Plate Anchors Wall Plate Screws Mounting Holes 2. Install the Wall Plate Carefully tap each wall anchor into the finished surface until flush. Secure the wallplate(s) with two screws.
Single Post Wall Plate Escutcheon Tissue Holder Setscrew 3. Install Single Post Accessories Tissue Holder, Towel Ring, and Robe Hook NOTE: All single post accessories install as shown. The tissue holder is shown. Partially thread the setscrew into the escutcheon. Align the escutcheon over the wall plate. Tighten the setscrew. Do not overtighten.
Triple Post Double Post Escutcheon Escutcheon Wall Plate Wall Plate Towel Bar Towel Bar Setscrew Setscrew P34403-00 P34401-00 4. Install the Towel Bar Partially thread a setscrew into each escutcheon. Place the towel bar assembly onto the wall plates. Tighten the setscrews. Do not overtighten.
USA/Canada: 1-888-4-KALLISTA Fax: 1-888-272-3094 kallista.