Installation Guide

1. Prepare the Site — Anchor Holes
For Multiple-Post Accessories
NOTE: Take into account the length of the accessory components to
determine the required distance between the post center points.
Consult the ″Roughing-In″ section for dimensions.
Mark the vertical and horizontal centerlines for each post. Use a
level to ensure that all center points are level.
Vertically align and mark the holes of each wall plate. Set the
wall plate aside.
For Single-Post Accessories
Mark the vertical and horizontal centerlines for the post. Consult
the ″Roughing-In″ section for dimensions.
Horizontally align and mark the holes of the wall plate. Set the
wall plate aside.
For the P34410 Towel Ring
Select a drill and 3/8” drill bit appropriate for the wall material
you will be drilling through.
Carefully drill a 3/8” hole at all marked pilot hole locations.
For All Other Accessories
Select a drill and 5/16” drill bit appropriate for the wall material
you will be drilling through.
Carefully drill a 5/16” hole at all marked pilot hole locations.
Centerpoint
Wall Bracket
Locate the Wall Plate
Holes
Level
Wall Bracket
Hole Locations
For multiple-post layout only.
1078044-2-A 4 Kallista