Installation Sheet

5/16"1/8"
1
For All Installations:
Loosen the setscrew and remove the
wall plate from the accessory.
X
P34401: 24" (610 mm)
P34402: 18" (457 mm)
Verify “X” against the measurements of
your product model.
6"
(152 mm)
8" (203 mm) –
12" (305 mm)
Recommended Tissue Holder
Location
Important Information
These products should be located and
mounted to a wall stud. While it is
possible to mount them to any surface,
a stud-mounted product will yield the
best results.
CAUTION: Risk of personal
injury.
Do not install where the product might
be used as a grab or support bar.
Record your model number below
for future reference:
4
For All Accessories:
Position the accessory onto the wall
plate(s). Tighten the setscrew(s).
Between Studs Or Into Tile:
Drill 5/16" holes. Insert the anchors.
Secure the wall plate(s).
3
Drywall Into Studs:
Drill 1/8" holes. Secure the wall
plate(s).
2
Single-Post Accessories:
Position the wall plate and mark the
holes. Verify plumb.
1314842-2-A