Use and Care Manual

17
www.KALORIK.com
EPCK 42941 - 170120
DO NOT IMMERSE THE HOUSING IN WATER OR ANY OTHER LIQUIDS!
To clean the valves
Check that the pressure regulator knob and the pressure safety
valves are in good working order before each use.
After the unit has cooled, remove the lid.
Turn the lid upside down and remove the anti-block shield. Check
the exhaust valve (also referred to as pressure regulator valve) and
clean if necessary.
Using a brush, check for and remove any food or foreign particles
that may be lodged in the exhaust valve or floating valve.
Replace the anti-block shield on top of the exhaust valve.
Any other servicing should be performed by an authorized service
representative!
TROUBLESHOOTING
If you have not added sufficient liquid and you notice that the floating
valve has not risen, but the timer is counting down, perform the
following steps:
Stop the pressure cooker by pressing the “Start/Keep
Warm/Cancel” button
Turn the steam release ring to the Steam/Open” position, until the
pressure is fully released.
Carefully remove the lid and add approximately 1 cup of
water/stock or any liquid. Stir food to disperse liquid.
Replace the lid and lock into position.
Select your desired preset menu and adjust the cooking time and
pressure if necessary. Press the +or - buttons and set the desired
time
Press the “Start/Keep Warm/Cancel” button to begin cooking
again.