Operation Manual

Operation procedure-Control under the Emergency operation switch
In case the batteries in the remote control are worn out, or remote control is
deficient, use emergency operation switch.
Every time the switch is pressed, it changes in sequences
of COOL HEAT STOP.
Emergency run operation procedures as the following:
Setting Temperature
Fan Speed
Deflector
24
o
C
High
Swing
Timer operation
 Timer operation ON
1. Press the button when the air conditioner is not operating to set the time at which you want it to
start operating. "l" of flickers on the remote controle display.
Press the button when the air conditioner is operating to set the time at which you want it to stop
operating. of flickers on the remote control display.
2. Press or to enter the time setting. Press or once, the timer will increase by 1 hour,
the time will be displayed on the remote control.
3. Press to fix the time setting. "l" or will stop flickering on the display of the remote control.
 Timer operation OFF
If you want to switch off the timer operation, press the button until the set time and or
disappear from the remote control display.
NOTICE
1. If power sets off, time must be set again, otherwise the timer operation will not be correct.
2. If the air conditioner has been in timer off but you want to change the time, you must cancel the
primary condition and then set a new time condition, otherwise, an error will occur.
3. When the air conditioner is operating with your previous setting time, you press once again, then
the timer will restart from the beginning. For instance, if you set the timer as 3 hours (it means the air
conditioner will stop or start 3 hours later), and press to start the timer. And after 2 hours (the
remaining time is 1 hour), you press again, then the timer will restart again from the beginning (it
means the remaining time is 3 hours now).