Operation Manual

Use putty to seal the wall
hole.
Use clamp (pipe fastener)
to secure the pipe at
specified position.
indoor unit
airproof with putty
clip the connecting pipe with clamp
get rid of unwanted part
screw
SEAL OF WALL HOLE AND FASTEN OF PIPE
1 Remove the self-tapping screws (2 pcs)
on the maintenance board and take out the
maintenance board.
2 Loosen the self-tapping screws (2pcs) on the fixing
clip to loosen the fixing clip.
3 Loosen the fixing screw of the wire terminal board,
pass the power wire and signal wire through the fixing
clip. Then firmly fix the power wire and signal wire on
the terminal board with the fixing screw. (Ground wire
must be connected firmly.)
The cable wire can be led from the back
hole of the piping hole or ejecting hole.
Please utilize outdoor pipe support when
the cable wire is led from the backside.
5 Install the maintenance board. After the pipes
and cable wire are installed, please seal the
sponge block as per drawing indication.
Outdoor pipe support
(Outdoor pipe support is not required
when leading the cable wire from other places).
Maintenance
board
Back wiring
Fix the cable wire
with anchor cable
Terminal board
Right wiring
Ejecting hole
Maintenance
board
Sponge
Piping cover
Connect diagram
Wiring
Piping cover
Piping cover
OUTDOOR UNIT
4. Tighten the self-tapping screw on the fixing
clip
Indoor unit terminal
Connecting cable
Outdoor unit terminal