Operation Manual
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
8 KA CM 520 S - 081119
Assembly page 8/24
Fax +32 2 359 95 50
(*)
Competent qualified electrician: after sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
INITIAL OPERATION
For a perfect taste, carry out 2 or 3 boil-processes with fresh water (without coffee). These
boil-processes are absolutely necessary.
Once all the water has passed through, switch the appliance off and let it cool down
during 5 minutes. Then repeat the process with fresh water.
PREPARATION OF COFFEE
WHEN YOU OPERATE YOUR APPLIANCE, MAKE SURE YOU DO NOT PUT THE LID ON THE THERMOS
FLASK.
Open the lid of the water tank.
Using the glass carafe, pour the desired amount of water into the water tank. Make sure
not to overfill by respecting the maximum level indicated on the water tank.
Place the filter holder into the coffee maker. Put a filter in the filter holder and add the
desired quantity of ground coffee in the filter.
Never forget to close the lid of the water tank and to place the glass carafe without its lid
on the plate before switching on your coffee maker.
Press the “power” button to switch on the coffee maker. The pilot light of the switch will be
illuminated, indicating that your appliance is working.
When you remove the jug from the appliance, a non-drip valve will automatically operate
to stop any drops of coffee dripping. Replacement of the carafe automatically opens the
non-drip valve and allows remaining coffee to filter through into the jug.
Wait until the brewing process is finished and the filter has run empty before removing the
jug.
Wait for the coffee to be brewed and for the filter to be empty. Switch off the appliance
by putting the ON/OFF switch on « 0 » and unplug the appliance.
Take off the thermos flask, screw the lid on the thermos. To pour coffee, you do not need
to unscrew the lid, you just have to push on the lever that protrudes from the lid.
The thermos flask allows you to keep the coffee warm for some time.
DECALCIFICATION AND CLEANING
When you notice that the coffee making process is longer than it should be, it is probably
time to decalcify the appliance. Do not wait until the situation gets worse. The
decalcifying frequency depends on the amount of lime in water and therefore can be
different from family to family. Therefore it is important to pay attention to this.
We advise you to descale the coffee maker to prolong its life span. For descaling, only use
products especially made for descaling of coffee makers and follow their instruction
manual. Then rinse the appliance twice with fresh water, without coffee powder.
Guarantee claims will not be accepted for appliances that have not been descaled.
Never use a dishwasher to clean the appliance or its accessories. Just clean the thermos
flask in soapsuds.
To clean the plastic parts of the appliance, use a damp, non abrasive cloth.