Ice cube maker USK ICBM 30116 USK ICBM 30155 www.KALORIK.
IMPORTANT SAFEGUARDS 1. READ ALL INSTRUCTIONS 2. Check that your mains voltage corresponds to that stated on the rating plate of the appliance before using the appliance. 3. To protect against electric shock do not immerse cord, plugs, the appliance or its control panel in water or other liquid. 4. Close supervision is necessary when the appliance is used by or near children. 5. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner.
SHORT CORD INSTRUCTIONS A short power supply cord is provided to reduce the hazards resulting from becoming entangled in, or tripping over a longer cord. Extension cords may be used if care is exercised in their use. • The electrical rating of the extension cord should be at least that of the appliance. If the electrical rating of the extension cord is too low, it could overheat and burn.
Note: Do not use the Ice maker near an oven, radiator, or other heat source. PART DESCRIPTION 1. 2. 3. 4. 5. 6. 7 8. Lid Ice collecting basket Front housing Water tank Filter Feet Evaporator Water inner tube 9 10. 11 12. 13. 14 15 Water drain plug Compressor Water pump Power cord Upper view Control panel Lid window CONTROL PANEL A. B. C. D. E. F.
OPERATION • • • • • • • • After having unpacked the appliance, clean water tank and ice basket thoroughly. Wait for 2 hours before taking the next step. Pour drinkable water in the water tank. Do not try to fill more than 50 Oz. water or above the level of the ice basket. To select the size of the ice cubes, press the SELECT button until the corresponding pilot light turns on. “S”: small, or “L”: large. Press START button to start the ice making process.
operation though, when the temperature in cavity will reach above 5°C/ 40°F CLEANING AND CARE • • • • • • • • • • • If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do not start the system right away, wait 3 minutes, and then re-start the Ice maker. Always add fresh water before starting ice production at initial installation or after long shut off periods.
TROUBLESHOOTING Problem Possible Cause Suggested Solutions “Add water“ indicator light is on, a long beep sounds There is no water Fill the water tank with water, wait 3 minutes and press the start button to restart. “Ice Full“ indicator light is on, a beep sounds The ice tank full capacity is reached Empty ice basket completely or partially, wait 3 minutes and press the start button to restart. My Ice melts The compressor has stopped automatically.
WARRANTY We suggest that you complete and return the enclosed Product Registration Card promptly to facilitate verification of the date of original purchase. However, return of the Product Registration Card is not a condition of these warranties. You can also fill this warranty card online, at the following address: www.KALORIK.com This KALORIK product is warranted for 1 year from the date of purchase against defects in material and workmanship. This warranty is not transferable.
If the appliance should become defective within the warranty period and more than 30 days after date of purchase, do not return the appliance to the store: often, our Consumer Service Representatives can help solve the problem without having the product serviced. If servicing is needed, a Representative can confirm whether the product is under warranty and direct you to the nearest service location.
10 USK ICBM 30116/30155 - 090716
11 USK ICBM 30116/30155 - 090716
www.KALORIK.