User's Manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame.
2 PCM 35546 - 120501
Assembly page 2/28
Fax [phone]
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should
always be followed, including the following:
1. READ ALL INSTRUCTIONS BEFORE USE
2. Check that your mains voltage corresponds to that stated on the
rating plate of the appliance before using the appliance.
3. Do not leave unattended while in use. Always unplug the
product from the electrical outlet when not in use.
4. Never plug in or operate the unit when empty, or when not fully
assembled.
5. DO NOT TOUCH Hot surfaces. This product will become hot when
in use. Use protective hand covering (oven mitts) to avoid burns
or serious personal injury.
6. To protect against electrical shock do not immerse cord, plug, or
the motor unit in water or other liquid.
7. Close supervision is necessary when the appliance is used by or
near children.
8. This product is not a toy! Please keep out of reach of children and
pets. This product is not intended for use by children, by persons
with reduced physical, sensory or mental capabilities, or lacking
experience or knowledge, unless they have been given
supervision or instruction concerning the use of the product, by a
person responsible for their safety. Extra caution is always
necessary when using this product.
9. The cover must be in place before plugging the product into an
electric outlet.
10. Never put more than 1 measuring cap (60g) of kernel into the
popping chamber, else kennels will not pop and the machine
could be damaged.
11. Do not move the product when in operation or heated.
12. Unplug from outlet when not in use and allow cooling before
putting on or taking off parts, relocating, servicing or before
cleaning.