Operation Manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
25 TKG DG 1000 - 100116
Assembly page 25/80
Fax [phone]
CLEANING AND MAINTENANCE
WHEN PROCESSING FOODS WITH COLOUR (E.G. CARROTS) SOME PARTS MAY BECOME
DISCOLOURED. FOLLOW THE CARE INSTRUCTIONS BELOW – THIS WILL NOT AFFECT THE
PERFORMANCE OF YOUR PRODUCT.
No part of the appliance (motor block, blending container, accessories) is dishwasher-safe.
Cleaning the base unit
 Always unplug the unit and make sure it is cold before cleaning it.
 Do not immerse the base unit in water or any other liquid.
 Clean the base unit with a slightly damp cloth only.
 Do not attempt to clean the base unit with any abrasives or cleaning solvent as this may
cause damage to the unit.
Warning!
 Always unplug the unit and make sure it is cold before cleaning it.
Cleaning the blade unit
 Remove the blade unit from the container.
 Rinse it thoroughly and remove any food residues.
 Clean it with soapy water or with a neutral detergent.
 Rinse it thoroughly and dry it immediately.
 Put the protective covers on and keep the blade unit out of the reach of children.
Warning!
 Always handle it very carefully as the blades are very sharp.
 Always put the protective covers on when unattended.
 Never use bleaching agents or chlorine based detergents as they may damage the
blades.
 Do not to put the blades in a dishwasher.
Cleaning the boiler (after each operation)
 Always unplug the unit and make sure it is cold before cleaning the boiler.
 Unfasten the boiler cap from the base unit by turning it anti-clockwise and lift it (fig. a).
 Check that the boiler is empty by turning the base unit upside down and see that no
water comes out (fig. k).
 Fill 230ml of water into the measuring beaker.
 Pour the water into the boiler carefully (fig. a).
 Secure the cap on the boiler by turning it clockwise (fig. b).
 Shake the base unit several times in different directions.
 Unfasten the boiler cap and empty the boiler over a sink.
 Repeat the above-mentioned steps if necessary.