Operation Manual

Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The pages must be reproduced and folded in order to obtain a
booklet A5 (+/- 148.5 mm width x 210 mm height). When folding,
make sure you keep the good numbering when you turn the pages
of the I/B. Don’t change the page numbering. Keep the language
integrity.
21 TKG MG 37 DGC - 081128
Assembly page 21/56
Fax [phone]

USE
IMPORTANT REMARKS:
1) There must be a food preparation in the oven cavity before starting the microwave oven.
2) Make sure the receptacle does not touch the walls of the cavity in order not to disturb the
rotation of the glass tray.
3) The metal rack supplied can be used in the “quartz grill – convection” function or the grill
function. It can be used to put the food nearer to the heating element or to put several
receptacles in the oven.
Each time a pad is pressed, a short beep will sound to acknowledge the press. When you start
turning the rotary knob, a short beep will sound as well.
When the appliance starts, the light inside the oven switches on in order to check the cooking.
The cooking time countdown begins.
At the end of the cooking time, three beeps will sound and the light inside the oven switches
off. The display will show “End”. If you do not press the “Stop.Clear” key or open the door, three
beeps will sound again every 3 minutes.
If you open the door during the cooking process, the oven stops. To continue cooking, close
the door and press "Instant.Start".
Anytime, if you press the "Stop.Clear" pad, the setting or the cooking process will be stopped.
SETTING THE CLOCK
When the microwave oven is plugged into a wall outlet, the display will flash 3 times and then
“:” will flash.
1. Press "Preset.Clock". “0:00” appears on the display.
2. Turn the rotary knob to set the hours (0-23). The hours will be flashing.
3. Press "Preset.Clock" again to confirm the hours. The last digits, indicating the minutes, will
start flashing.
4. Turn the rotary knob to set the minutes (0-59).
5. Press "Preset.Clock" again to finish the setting or wait 5 seconds.
Note: If you press “Stop.Clear” during the process of clock setting, the oven will go back to the
previous status automatically.
If time resetting is needed afterwards, press "Preset.Clock" and proceed as described above.
SETTING THE COOKING TIME, POWER AND COOKING FUNCTION
Important remark: Make sure the door of the oven is closed before you press "Instant.Start",
otherwise the oven will not function.
a) Microwave cooking
1. Select the desired power by pressing “Micro Power” once or a number of times (for the
power level regulation, see table below).
Power
100%
80%
60%
40%
20%
Display
P100
P80
P60
P40
P20
Function
Meat,
vegetables
Eggs, fish,
rice, soup
Steaming
Defrosting
Keeping
warm
2. Turn the rotary knob to set the cooking time (maximum 60 minutes).