Operation Manual

LP Cylinder Requirements
• The LP cylinder must be constructed and marked in accordance with the
specifications for LP gas cylinders of the U.S Department of Transportation (DOT).
• Cylinders must be secured using the provided cylinder retention system to
avoid accidental movement.
• When exchanging your cylinder for a refill, exchange only for a Type 1 20lb
cylinder with an over-fill protection device.
• Never use a cylinder with a damaged valve.
• A dented or rusty LP cylinder may be hazardous and must not be used. If in
doubt, have it checked by your LP supplier.
• Always check for leaks after every LP cylinder change.
• Always shut off the LP-gas supply at the cylinder when the grill is not in use.
• Cylinders must be stored outdoors in a well-ventilated area out of the reach of
children. If your grill is stored indoors, the LP cylinder must be stored outside
Gas Line Purging
• You should purge the gas line of air before attempting to light the grill.
• Make sure all grill controls are in the “OFF” position.
• Slowly turn on the main gas supply.
• Hold the knob on for about 5-20 seconds to allow the air in the system to
purge and the burners to light.
• Wait at least 5 minutes after shutting off the control before attempting to
light the burners.
12
Figure 8