User guide

Back Panel I/O and Labeling

Each back panel has terminal blocks used for I/O with special laser markings depending on

the cards installed in the rack. The half rack has one 12 position terminal block, the 3/4 and

full racks have two 12 position terminal blocks. The outputs are labeled to be consistent with

the table below where `x' refers to the channel number. Unfortunately, because of the density

of the outputs on the back plane vs. the available outputs on the terminal blocks all outputs

will not always be available on the terminal block. If you need a specific output not provided

on the back panel terminal block please call the factory for information. If you have a function

card not listed here please refer to the manual for the specific function card on terminal block

labeling information.

Module label Function

8200 CHx Signal out of measuring channel

GND Ground from measuring channel

8200HT CHx Signal out of measuring channel

GND Ground from measuring channel

VC8000 +Ix Hi side current out of measuring channel

-Ix Lo side current out of measuring channel

SP8000 SHx Hi set point OC output for CHx

SLx Lo set point OC output for CHx

CEx common emitter output for CHx setpoints

GHx Go set point high for CHx

GLx Go set point low for CHx

SC8000 x+/-x Summed Output

SHx Hi set point output for CHx

SLx Lo set point output for CHx

CEx common emitter output for CHx

DY8000 PPX Peak-to-Peak or Positive peak for CHx

NPX Negative Peak for CHx

RMx RMS for CHx

SHx Hi set point output for CHx

SLx Lo set point output for CHx

CEx common emitter output for CHx

Any GND Ground

+V +15 volt from internal supply or +15V input

-V -15 volt from internal supply or -15V input

Table 3 -- Terminal Block Labeling;