Manual

www.kamansensors.com PART NO: 860525-001
Last Revised 9/16/2013
- 5 -
PART 2 – CONNECTIONS
The digiVIT I/O connections are all through a 10 pin removable terminal block. The DigiVIT
sensor is connected through an SMA coaxial connector on the opposite side of the enclosure.
An RJ45 Ethernet connection is provided for UDP/IP communication.
Pin Name Function
1 +24V
+24V Input @ 0.13A
(must accommodate power-on surge current up to 300mA)
2 Gnd Ground
3 Vout Voltage Output (0-5, +/-5, 0-10, +/-10)
4 Gnd Ground
5 Iout Curent Loop Output (0-20mA, 4-20mA)
6 Gnd Ground
7 NC No Connection
8 IO IO Bit for special functions -- standard setup for Autozero when grounded.
9 Relay Solid State Relay Connection
10 Relay Solid State Relay Connection
Table 1 Terminal Block Pin-Out