Snugasabug Fitted Electric Blanket ® Suits models KEB413/KEB433, KEB513/KEB533 (with polyester fleece cover) KEB413_IB_FA.
Important Please retain your instruction book for future use. In the event that you need some assistance with your Kambrook appliance, please contact our Customer Service Department on 1300 139 798 (Australia) or 09 271 3980 (New Zealand). Alternatively, visit us on our website at www.kambrook.com.au KEB413_IB_FA.
Contents Kambrook Recommends Safety First p4 Your Snugasabug® Fitted Electric Blanket p6 Using your Snugasabug ® Fitted Electric Blanket p7 Care and Cleaning p10 Warranty Details p12 KEB413_IB_FA.
Kambrook Recommends Safety First IMPORTANT: Please retain your instruction book for future use. Electric Blanket Type: KEB110, KEB210, DEB100 and DEB200 At Kambrook, we believe that safe performance is the first priority in any consumer product, so that you, our valued customer can confidently use and trust our products. We ask that any electrical appliance that you use be operated in a sensible fashion with due care and attention placed on the following important operating instructions.
• • • • • • • that the blanket be frequently inspected to ensure that this condition is being maintained. Regularly inspect the electric blanket, power supply cord, plug and controller for any wear, damage or misuse. If signs of these are detected, immediately cease use of the appliance and return the entire unit to your nearest Kambrook Service for examination, replacement or repair. Bed clothes should not be folded back when the blanket is switched on.
Your Snugasabug® Fitted Electric Blanket KEB413 KEB433 KEB513 KEB533 1. 2. 3. 4. Large Single Double/Queen Large Single Double/Queen approximately 900x1880mm approximately 1460x1880mm approximately 900x1880mm approximately 1460x1880mm Fully fitted design with skirt (40cm skirt for KEB413 and KEB513. 45cm skirt for KEB433 and KEB533). Machine washable and tumble dry electric blanket. Removable fleecy cover for easy cleaning (KEB513 and KEB533 models only).
Using Your Snugasabug® Fitted Electric Blanket Before First Use Remove any promotional material and packaging from the electric blanket. Securing Your Fitted Electric Blanket Place the electric blanket on the mattress, so that the skirt is visible and the controller is under the electric blanket and exits through the skirt aperture. Ensure the heating wire section on the electric blanket is clear of the pillow. Pull the elastic inside the fitted skirt over the ends of the mattress.
Using Your Snugasabug® Fitted Electric Blanket continued Pass the controller and cord through the apertures in the skirt section of the blanket. Ensure that when the blanket is fitted onto the mattress the controller/s and flexible power supply are outside of the bed and coverings and located in a position that will prevent accidental damage to the housing and cords Use this blanket only as an under blanket and do not use above the occupant of the bed.
Setting the Heat Temperature Your 6 heat controller features an ON/ OFF slide switch plus an easy to use dial to select the temperature setting. To switch the blanket off, move the switch in an upward direction to the ‘OFF’ position. NOTE: On initial use it is recommended that the blanket be set on ‘6’ for 3 hours before sleeping on the bed. This will assist in drying out any moisture which has been accumulated in the mattress.
Care and Cleaning Do not dry clean. Do not iron. Use only the following instructions: Before cleaning, ensure that the controller is unplugged from the power supply and detached from the blanket. Spot Cleaning Sponge the affected area using a luke warm neutral detergent or mild soapy solution. Follow this with a sponging using a clean water solution. Remove any excess water by compressing the wet area between absorbent towels.
DO NOT wash on a HOT cycle, the temperature must be kept below 40°C. Do not use high speed or extra spin cycles. Drying Drape the electric blanket across a clothes line and drip dry. DO NOT use pegs to secure the electric blanket in position. DO NOT dry with a hair dryer or heater. Tumble Drying You may tumble dry your blanket on LOW setting for 15 minutes MAXIMUM. Smooth the blanket by gently pulling any creases out of the fabric. Do not dry with the control/s connected to the blanket.
Kambrook 36 Month Replacement Warranty The Kambrook Replacement Warranty does not apply to any defect, deterioration, loss, injury or damage occasioned by, or as a result of, misuse or abuse, negligent handling or if the product has been used other than in accordance with the instructions. The Kambrook Replacement Warranty excludes breakables such as glass and ceramic items, consumable items and normal wear and In New Zealand, this Kambrook Replacement Warranty does not affect your mandatory statutory tear.