User's Manual

7
Operating Instructions
Before First Use
Remove any promotional material
from the vacuum cleaner.
When unpacking the vacuum cleaner
check to see you have received all
the required components, such as the
hose and other accessories before
discarding the packaging.
To Operate the
Vacuum Cleaner
Locate the crush proof hose and push
the connection point into the hose
inlet connection on the front side of
the vacuum, until a “click” sound
is heard.
Connect the wide end of the metal
wand to the hose end, and push
together firmly.
Fit the floor tool to the narrow end of
the wand and push together firmly.
Fully extend the power cord by pulling
the power plug out from the rear of
the vacuum, until the yellow tape on
the cord is showing.
NOTE: Ensure that you do not
over extend the power cord
– do not extend past the red
warning tape on the cord.
Plug into a 230/240V power point and
switch the power on at the power
point.
To commence vacuuming, push down
on the on/off button
on/off cord
press
& lift
up
down
on the top of
the vacuum cleaner.
When vacuuming is complete, push
down on the ‘on/off’ button to switch
off. Turn the power off at the outlet
and then remove the power cord
from the power outlet. When removing
the plug from the power outlet, grasp
the plug not the cord.
To retract the cord push down on the
‘cord rewind’ button
on/off cord
press
& lift
up
down
on top of the
vacuum cleaner.
IMPORTANT: Hold the
plug end and guide the
cord into the vacuum
during retraction to
prevent it from striking
you or the vacuum.
CAUTION: Always
ensure that the dust
container and the
motor protection filter
are correctly fitted.
Never operate without
the dust container or
filters in place.
Fig. 1
Fig. 2
KBV250-220-280_IB_B11.indd 7 23/08/11 10:12 AM