INSTRUCTION BOOKLET KTF840_841_WHT_IB_C18.
Important Please retain your instruction book for future use. In the event that you need some assistance with your Kambrook appliance, please contact our Customer Service Department on 1300 139 798 (Australia) or 0800 2738 45 (New Zealand). Alternatively, visit us on our website at www.kambrook.com.au or www.kambrook.co.nz KTF840_841_WHT_IB_C18.
Contents Kambrook Recommends Safety First p4 Your Kambrook 87cm or 114cm Touch Control Tower Fan p6 Quick Start Guide p7 Using Your Tower Fan p8 Care, Cleaning and Storage p13 KTF840_841_WHT_IB_C18.
Kambrook Recommends Safety First IMPORTANT: Please retain your instruction book for future use. At Kambrook, we believe that safe performance is the first priority in any consumer product, so that you, our valued customer can confidently use and trust our products. We ask that any electrical appliance that you use be operated in a sensible fashion with due care and attention placed on the following important operating instructions.
• Switch off the tower fan and unplug at the power outlet, prior to assembling, cleaning and storing the tower fan. • Do not place anything, on top of the fan when assembled, when in use and when stored. • Store the unit out of reach of children. • Keep the tower fan clean. Follow the cleaning instructions provided in this book. Important Safeguards For All Electrical Appliances • Fully unwind the power cord before use. • Connect only to a 230V or 240V power outlet.
Your Kambrook Tower Fan 1. Touch control panel featuring: 7. Carry handle • POWER On/Off button • Fan SPEED button (Includes 3 speed settings; low, medium and high) • MODE button (includes 3 cooling modes; nature and reduction mode) • TIMER button (up to 7 hours) • OSC button to set oscillation 8. Remote control storage 9. Detachable filter cover 2. Tower fan body 3. Remote control signal receiver 4. Oscillating platform 5.
Quick Start Guide Turning the tower fan on OSC 4h 2h 1h MODE TIMER SPEED OSC 4h 2h 1h POWER Plug the power cord into a 230V or 240V power point and switch on. To start the tower fan, turn the tower fan on by pressing the ‘POWER’ button once. OSC MODE Setting the fan speed 4h 2h 1h TIMER SPEED 2h 1h POWER Pressing the ‘SPEED’ button once will set the tower fan into MEDIUM speed setting.
Using Your Kambrook Tower Fan Before first use 3. Remove your tower fan from its carton and associated protective wrapping. Unwind the cord to its full length and remove any protective cardboard or foam that may have been used to minimise transportation damage. Once assembled by following the directions below, place the tower fan on a firm, level surface in a stable upright position. Visually inspect the air inlet and outlets to ensure no foreign material is blocking these areas.
Using Your Kambrook Tower Fan continued To assemble the KTF841WHT base stand (2 pieces): 1. 2. The tower fan base stand comes in two separate pieces that connect with one another. To assemble the base stand, place the tower fan body on its side. Remove the 3 fastening screws from underneath the tower fan section of the fan and set aside. (See Fig. 5). Fig. 5 3.
Using Your Kambrook Tower Fan continued NOTE: To avoid infrared interference that may trigger the operation of the cooling fan, ensure the fan is positioned away from other infrared remote controlled appliances. Fig. 9 Thread the power cord through the circle cord opening located in the base stand piece, pressing into the cord clip to keep it secure. (See Fig. 10). WARNING: Make sure the power cord is not trapped between the base stand pieces and tower fan body.
Using Your Kambrook Tower Fan Setting the Nature and Reduction Mode Your tower fan has a NATURE and REDUCTION setting. Both the NATURE and REDUCTION modes can be used on any fan speed. The LED screen will indicate what mode the fan has been set in. Nature Mode The NATURE mode simulates the natural rise and fall of the wind over time, with speed settings automatically cycling between low, medium and high. At any fan speed setting, pressing the MODE button once will turn the tower fan into NATURE mode.
Using the Remote Control Before using the remote control, remove the battery isolating slip by pulling the slip away from the remote control. The remote control buttons operate in the same way as those on the tower fan control panel. Your remote control includes 1 x CR2025 3V Lithium battery, and can be conveniently stored in the compartment at the rear housing of the unit.
Care, Cleaning and Storage 1. 2. 3. 4. Ensure that the tower fan is switched OFF and disconnected from the power outlet before cleaning. Use a clean, dry cloth to clean the external surfaces of the tower fan. If the tower fan has collected dirt inside the unit, have the unit cleaned by a qualified service agent. Do not operate the tower fan in this condition. Do not attempt to open the case of the tower fan at any time as there are no customer serviceable parts inside.
Care, Cleaning and Storage Cleaning the Filter Fig. 11 Fig. 12 The filter is located behind the rear cover of the fan. To clean the filter: 1. Ensure that the tower fan is switched OFF and disconnected from the power outlet before cleaning. Gently unsnap the rear filter cover from the tower fan (See Fig. 11) and remove the filter (See Fig.12). Run the filter under cool water and gently rub to remove the accumulation of particles.
Notes 15 KTF840_841_WHT_IB_C18.
Kambrook - Australia Ground Floor, Suite 2, 170-180 Bourke Rd Alexandria NSW 2015, Australia Locked Bag 2000 Botany NSW 1455 Customer Service Line 1300 139 798 Customer Service Fax 1800 621 337 www.kambrook.com.au Kambrook - New Zealand Private Bag 94411 Botany, Manukau Auckland 2163 New Zealand Customer Service Line/ Spare Parts 0800 273 845 Customer Service Fax 0800 288 513 www.kambrook.co.