Steamline Iron Instruction Booklet KI730/KI760/KI760P/KI780 KI730_KI760_KI760P_KI780_IB_FA.
Important Please retain your instruction book for future use. In the event that you need some assistance with your Kambrook appliance, please contact our Customer Service Department on 1300 139 798 (Australia) or 09 271 3980 (New Zealand). Alternatively, visit us on our website at www.kambrook.com.au KI730_KI760_KI760P_KI780_IB_FA.
Contents Kambrook Recommends Safety First p4 Your Kambrook Steamline Iron p6 Operating Instructions p7 How To Use Shot Of Steam p10 Care and Cleaning p12 Warranty Details p16 KI730_KI760_KI760P_KI780_IB_FA.
Kambrook Recommends Safety First IMPORTANT: Please retain your instruction book for future use. At Kambrook, we believe that safe performance is the first priority in any consumer product, so that you, our valued customer can confidently use and trust our products. We ask that any electrical appliance that you use be operated in a sensible fashion with due care and attention placed on the following important operating instructions.
• Always test the iron on a small, discreet part of the fabric to be ironed to ensure the temperature is not set too high. • Always store the iron in the upright position on its heel. Do not leave the iron unattended while connected or on an ironing board. • Do not use outdoors or in bathrooms. • Do not store the iron with water in the water tank. Always empty the tank after use. Ensure the iron is cool before storing or wrapping the cord around the storage heel facility.
Your Kambrook Steamline Iron 1. Shot of steam button: For an extra burst of steam on thick fabric or tough creases 2. Fine mist spray: To dampen fabric especially when dry ironing at low temperatures when steam isn’t available (also assists in removing stubborn creases). 3. Steam control: Allows you to select how much or how little steam you require 4. Water tank inlet: Large inlet for easy filling of water tank 5. Fine mist spray nozzle 6. Self-clean function 7. 280ml easy to fill water tank 8. 2000W 9.
Operating Instructions Before First Use Remove any promotional material from the iron. Remove any sticker or protective cover from the soleplate. When operating the iron for the first time, iron on an old piece of fabric to ensure that the soleplate and water tank are completely clean. When the iron is used for the first time, some vapour may emit. After a short while however, this will cease. The vapour is due to the initial heating of the materials used in the iron.
Operating Instructions continued Setting the Temperature Before commencing ironing, first sort the items to be ironed according to the International Textile Care Labelling Code or by the type of fabric. Iron fabrics that require the lowest temperatures first. Work through to the fabrics requiring higher temperatures. Both the Temperature Control and most items of laundry have markings corresponding with this code (see Table A). Stand the iron on its heel and turn the Temperature Control to MIN.
Steam Ironing When filling the iron with water, ensure that the iron is unplugged. Set the Steam Control to the DRY position and holding the iron at an angle use the water cup supplied to fill the water tank. Never exceed the maximum water level as indicated (MAX) on the side of the water tank. Tap water can be used in your Kambrook Steamline iron unless it is particularly hard, in which case it is recommended that distilled or demineralised water be used.
How To Use Shot Of Steam The shot of steam provides an extra burst of steam which is ideal for the removal of stubborn creases and wrinkles during STEAM or DRY ironing. Turn the Temperature Control to the hottest setting and wait until the heating indicator light goes out. Ensure the Steam Control corresponds to the setting on the Temperature Control. Lift the iron slightly above the surface of the fabric, press the Shot of Steam button down firmly and release it during ironing.
Safety Auto-Off (KI780 Only) The Safety Auto Off feature is designed to switch the iron off if forgotten. When the iron is left in the upright position it will shut off in approximately 8 minutes, followed by six beeps. Fig. 1 When left in the ironing position it will switch off in approximately 30 seconds, followed by six beeps. Caution: safety auto-off is designed as a safety feature only. Irons should not be left switched on deliberately while unattended.
Care and Cleaning To ensure your iron maintains optimum performance it is recommended that it be cleaned using the Self-Clean function to remove scale or impurities. • Set the steam selector to the DRY position. • Fill the water tank up to the maximum level (MAX) with the water cup supplied. • Set the Temperature Control to MAX (Linen) setting. • Place the iron in the upright position, insert the plug into the power outlet and switch the iron on.
NOTE: Never use abrasives or scouring pads to clean the soleplate. Avoid hard contact with metal objects. Do not scratch or damage the surface of the soleplate. Do not use harsh or abrasive cleaners as they may damage the surface of the iron. Never immerse the iron in water or any other liquid. 13 KI730_KI760_KI760P_KI780_IB_FA.
Notes 14 KI730_KI760_KI760P_KI780_IB_FA.
Notes 15 KI730_KI760_KI760P_KI780_IB_FA.
Kambrook 12 Month Replacement Warranty The Kambrook Replacement Warranty does not apply to any defect, deterioration, loss, injury or damage occasioned by, or as a result of, misuse or abuse, negligent handling or if the product has been used other than in accordance with the instructions. The Kambrook Replacement Warranty excludes breakables such as glass and ceramic items, consumable items and normal wear and In New Zealand, this Kambrook Replacement Warranty does not affect your mandatory statutory tear.
