Installation Manual

7
2.4. Wi-Fi Connection Setup through Ethernet Cable
If your router is not compatible with “Wi-Fi Connection mode”, this is an alternativ mode for Wi-Fi
connection setup.
1) Follow Step 1- Step 4 in Wi-Fi Connection Mode Setup and then click “Ethernet Connection” icon to
start the Wi-Fi Connection Setup through Ethernet Cable (Figure13).
2) Use a RJ45 network cable to connect the camera with your router, wait for 120 seconds until it
automatically detects the device and bring you to the next step (Figure 14).
3) After the wired network connection is successful. It requires you to change the default password at
your first time use (Figure 15). Please click the “Apply” button after entering your password twice in
the input box;
4) After modify the initial password, it will bring you to the “Config Wi-Fi” screen . Click the right arrow at
the first input box and choose your home Wi-Fi, you will be directed back to the “Config Wi-Fi” screen
with enter the WiFi password (Figure 16);
5) Once the Wi-Fi set up, you will see the screen like step 10 – step 11 in Wi-Fi Connection Mode.
Figure 13 Figure 14