User's Manual

When alarm sounds, press SNOOZE to activate the snooze time for 9 minutes.

The AL1 / AL2 indicator keeps blinking.

This clock radio can switch to standby mode automatically after a preset period.

1. Press / FUNCTION to radio mode.

2. Press SNOOZE/DIMMER/SLEEP multi-function button repeatedly for 2 seconds to

select the sleep timer period (in minutes).

To deactivate the sleep timer, press SNOOZE/DIMMER/SLEEP multi-function button

repeatedly until back to OFF.

Sleep Timer period circle as follow :

While listening, press + VOLUME – to adjust volume.

Press DIMMER repeatedly to select high or low brightness levels.

changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interfer-

ence to radio communications. However, there is no guarantee that interference will

not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encour-

aged to try to correct the interference by one or more of the following measures:

90 > 80 > 70 > 60 > 50 >40 >30 >20 > 10

OFF

SET ALARM TIMER

SNOOZE ALARM

ADJUST VOLUME

ADJUST DISPLAY BRIGHTNESS