User's Manual

When alarm sounds, press SNOOZE to activate the snooze time for 9 minutes.
The AL1 / AL2 indicator keeps blinking.
This clock radio can switch to standby mode automatically after a preset period.
1. Press / FUNCTION to radio mode.
2. Press SNOOZE/DIMMER/SLEEP multi-function button repeatedly for 2 seconds to
select the sleep timer period (in minutes).
To deactivate the sleep timer, press SNOOZE/DIMMER/SLEEP multi-function button
repeatedly until back to OFF.
Sleep Timer period circle as follow :
While listening, press + VOLUME – to adjust volume.
Press DIMMER repeatedly to select high or low brightness levels.
changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
BATTERY BACK-UP
5
(For Temporary Time Storage Only)
Install 2 x LR06, AA or EU-3 battery (not included) according to polarity shown inside the battery
compartment. In the event of a power interruption, your set will not work normally from the
mains supply but there is now the advantage that your clock will continue to work. The clock
display will not light up, as the clock time will be held in the memory. This also enables you to
move the set from place to place without re-setting the clock every time. The battery back-up
system is only meant to be used from short temporary power interruption. For longer durations,
the battery may become exhausted or there may be some deviation in accuracy. When the
battery is exhausted, it should be removed from the set to prevent leakage. If you do not wish to
take advantage of the battery back-up system, your set will work normally without a battery.
However, if disconnected from the mains, the clock figures will flash when the mains are
re-connected and you must re-set the clock as described in the Electronic Clock Operation
paragraph.
Attention should be drawn to the environmental aspects of battery disposal. Don’t throw used
batteries in dustbin. Please contact your retailer in order to protect the environment.
Attention should be drawn to the environmental aspects of battery disposal.
Electrical products should not be disposal of with household waste. Please recycle where
facilities exist. Check with your Local Authority of retailer for recycling device.
(Batteries pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire
or the like.
SPECIFICATION
Power Source : AC 110-240V ~50/60Hz VDE External adapter
Tuner Range : FM 87.5-108.0MHz
Power Consumption : 3.5W
Product information is subject to change without prior notice.
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.