User's Guide

User Guide
❶ 开机并连上电脑，长按模式键3秒
❷ 相机重启，并进入U盘模式
❸ 将固件拷贝到相机U盘
❹ 关机重启，进入系统升级，蓝灯快闪，升级完成，蓝灯恢复常亮
固件升级
❶ 相机连接上12V 3.5A适配器，
❷ 按下镜头组件，镜头组件自动弹起，机器启动中，红灯常亮，启动完成蓝灯慢闪。
❸ 用USB线连接电脑和相机
❹ 打开会议视频平台（如QQ，小贝壳会议系统，Skype，ZOOM等），接入远程会议，此时蓝灯常亮
❺ 可以通过相机端控制音量大小和麦克风静音，以及会议模式切换
❻ 会议完毕，按下镜头组件，10秒后相机关机完成
连接使用
适配器
USB
适配器
USB
cn cn
包装清单
❺ 保修卡
WarrantyUser Guide
❶ 全景会议摄影机 ❷ 12V 3.5A适配器 ❸ USB A公头转TYPE-C线 ❹ 说明书
部件介绍连接使用固件升级
声明
❶ 请阅读这些说明;
❷ 请注意所有警告;
❸ 请遵循所有说明;
❹ 切勿在散热器、电热器、炉子、或其它产热设备等热源附近进行工作;
❺ 仅使用制造商为Kandao按指定和提供的附件与配件;
❻ 请将所有维修工作交由符合资质的人员处理。不论设备受到何种形式的损坏，例如电源线或插头损坏，液体渐入或物体落入此设备淋雨或受潮，
无法正常工作或坠落，均需进行维修。
摄像机的安全
警告：如果你未能采取下列预防措施，则可能会因电击或火灾造成严重伤害或死亡，或者造成你的全景会议摄影机受损，使用摄像机和配件前请进行检查，确保其完
好无损。处于安全原因，全景会议摄影机只能使用随附的或另行购买的正品Kandao配件。如使用并非由Kandao推荐的任何其它部件、配件或充电器，可能导致火
灾、触电或人身伤亡。
❶ 切勿将本产品置于或固定在不稳定的表面上。不遵守此预防措施可能会导致产品松开或者脱落，从而引发事故或损坏摄影机。
❷ 使用外部电源连接，请遵守第三方供电设备的所有安全准则。
❸ 全景会议摄影机镜头采用玻璃制成。如果镜头破坏，请务必小心处理，避免被破碎的玻璃划伤，切勿让儿童接触。
❹ 摄像机在运行时温度可能会升高，这是使用过程的正常现象。在这种情况下，关闭相机，将摄像机静放至冷却后再尝试使用。
❺ 本产品并非玩具，您应全权负责遵守当地的所有法律、法规和限制。
❻请勿将全景会议摄影机用于未经授权的监控、偷拍或以侵犯个人隐私法规的任何方式使用。通常情况下，严禁将摄像机用于此类用途，并且可能会致使操作者承
❼ 注意事项：请勿将摄像机置于极冷或极热的环境中，极冷或极热条件可能会导致相机暂时不能正常工作。
❽ 警告：全景会议摄影机的2个镜头没有任何保护，如果不注意则很容易形成划痕。避免将镜头放置在任何表面上，镜头划痕不在保修范围内。
担重大责任和面临刑事诉讼。
cn cn
控制单元
摄像头组件
环形灯带
内置两个扬声器
外接线接口处
模式切换
减音量
麦克风
加音量
静音键
DC接口
USB接口
RJ45接口
部件介绍
cn
该符号表示，根据当地法律法规，您的产品应和家庭垃圾分开处理。当产品寿命终止时，请将其带到地方当局指定的回收点。弃置产品时对其进行分开收集与回
收有助于保护自然资源，并确保以有益人体健康和保护环境的方式进行回收。
FCC ID:2ATPV-KDWL
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Control unit
Lens module
Ring lamp
Built-in speaker
Extended cable port
Switch mode
Vol- Vol+
Mute
DC port
USB port
RJ45 port
Parts Description
Microphone
cn en
部件介绍连接使用固件升级
Statement
Camera Security
Warning: If you fail to take the following precautions, you may be seriously injured or killed by the electric shock or fire disaster, or your Intelligent 360 degree
panoramic camera may be damaged: Please check before using the camera and accessories to make sure they are intact. For security, only Kandao accesso-
ries that are provided with the device or genuine ones purchased can be used. Using any other parts, accessories, or chargers not recommended by Kandao
may result in fire, electric shock, or causalities. Damage caused by the use of unauthorized accessories or parts is not covered by the warranty.
❶ Please read these instructions.
❷ Please pay attention to all warnings.
❸ Please follow all instructions.
❹ Never operate the device near heat sources such as radiators, heaters, stoves, or other heat generating equipment
❺ Only use accessories and parts specified and provided by the manufacturer for Kandao.
❻ All maintenance should be conducted by the qualified personnel. Repairs are required in case of any types of damage to the device, for exam
❶ Do not place or fix the product on an unstable surface.Failure to follow this precaution may cause the product to loosen or fall off, causing an accident or damage to
❷ When using external power supply connection, please observe all safety rules of third-party power supply equipment.
❸ The le ns of Intelligent 360 degree panoramic camera is made of glass.If the lens is damaged, be sure to handle it carefully to avoid being scratched by the broken
❹ The temperature of the camera may rise during operation, which is a normal phenomenon during use.In this case, turn off the camera and leave it to cool before
❺ This product is not a toy and you are solely responsible for complying with all local laws, regulations and restrictions.
❻ Please do not use the Intelligent 360 degree panoramic camera for unauthorized monitoring, candid shooting or in any way that violates personal privacy regulations.Normally,
❼ Precautions: do not put the camera in extremely cold or hot environment. Extremely cold or hot conditions may cause the camera to temporarily not work properly.
❽ Warning: there is no protection for the two lenses of the Intelligent 360 degree panoramic camera. If you do not pay attention, it is easy to form scratches.Avoid placing the
lens on any surface. Lens scratches are not covered by the warranty.
ple, power cord or plug damage, liquid or object falling into the device, or getting wet in the rain or dampness, or failure to work or falling.
the use of cameras for such purposes is strictly prohibited and can result in significant liability and criminal proceedings against the operator.
glass and keep out of the reach of children.
the camera.
trying to use it.
Packing List
❺ Warranty Card
WarrantyUser Guide
❶ Camera ❷ 12V 3.5A Adapter ❸ USB ❹ User Guide
en en
This symbol indicates that your product should be handled separately from household waste according to local laws and regulations. When the
product life ends, please take it to the collection site designated by the local authority. The separate collection and recycling of discarded products
are helpful to the protection of natural resources. Besides, please make sure that they are recycled in ways that are beneficial to the human health
FCC ID:2ATPV-KDWL
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
en
说明书（骑马钉）
成品尺寸：156*102
128G双铜， 4C印刷+哑油
适配器
USB
Connection Information
❶ Get camera connected with 12V 3.5V adapter.
❷ Press lens module to start the camera, blue instruction light will blink slowly when camera is ready for work.
❸ Connect PC with camera via USB.
❹ Start video conference platform(QQ, Skype, ZOOM, etc), enter distant conference, instruction light would be steady blue.
❺ Click camera buttons to turn down/up voice, mute microphone, and switch modes.
❻ When conference is dismissed, press lens module to turn off camera.
Firmware update
Adapter
❶ Turn on the camera and get it connected with PC, long hold mode button for
3 seconds.
❷ Camera would be restarted and enter USB mode.
❸ Copy firmware to camera USB.
❹ Restart the camera to enter system update, when the update is done,
blue light would turn to steady blue.
en en
USB
12V 3.5A
USB
产品名称： 全景会议摄影机
型号： WL0308
制造商： 深圳看到科技有限公司
地址： 深圳市南山区科文路9号中钢大厦M7栋5D
Product Name: Intelligent 360 degree panoramic camera
Model: WL0308
Manufacturer: Kandao Technology Co.,Ltd.
Address: Unit 5D, Block M7, SinoSteel Building,
Nanshan, Shenzhen, China