User's Manual

INTRODUCTION
This Manual describes the operation for the Kanematsu Land mobile radio
This Land Mobile is full-featured FM transceiver designed for flexible mobile and base station
business communications in the VHF or UHF Land mobile bands.
This Land mobile radio can be programmed with 128 channels. This Land mobile include a 16
segment, 8character, numeric display for channel display.
Important channel frequency data is stored in EEPROM and flash memory on the CPU,
and easily programmable by dealers using personal computer and PC EDITER software.
FCC Requirements- RF Radiation Exposure- for Occupational Use Only
Your radio must be properly licensed Federal Communications Commission prior to use. Your
Wireless dealer can assist you in meeting these requirements. Your dealer will program each
radio with your authorized frequencies, signaling codes, etc., and will be there to meet your
communications needs as your system expands.
To ensure that your exposure to RF electromagnetic energy is
within the FCC allowable limits for occupational use , always
adhere to the following guidelines.
CAUTION
Antennas used for this transmitter must not exceed an antenna gain of 3dBi. The radio must
be used in vehicle-mount configurations with a maximum operating duty factor not exceeding
50%, in typical push-to-talk configurations. This radio is NOT approved for use by
the general population in an uncontrolled environment. This radio is restricted
occupational use, work related operations only where radio operator must have
the knowledge to control the exposure conditions of its passengers and
bystanders by maintaining the minimum separation distance of 2 feet(0.7meters)
between any persons and the antenna . Failure to observe these restrictions will
result exceeding FCC RF exposure limits.
Do not operate the radio without a proper antenna attached. As this may damage the radio
and may also cause to exceed FCC RF exposure limits.
Always use authorized accessories.