Setup guide

4
6
Connection Diagram
Local Monitor
Output
VGA Display
Speakers
Cat 5e/6 1000ft (300m)
VGA Cable
Stereo Audio
VGA Cable
Stereo Audio
VGA Cable
Source Display
5
Connection and Operation
1) Connect VGA source(PC, laptop, etc) and the 3.5mm audio cable to the VGA and stereo audio
input of the VGA Extender Tx unit.
2) ConnectCAT5outputfromtheTxtotheVGAExtenderRxunitusingaUTPCat5e/6cable.
3) Plug local VGA display to the VGA Output and Audio Out on the Tx unit.
4) ConnectVGAdisplay(Monitor,Projector,etc)totheVGAoutputontheRxunitaswellasthe
audio out to the display.
5) AddpowersuppliestotheTxandRxunits.
6) PowerontheTxandthentheRxunits.
Note:ereceiversconsistoftworotarydialsusedforgainandpeaking.Gainisusedforadjustingthebrightnesson
the displays and peaking is used for adjusting the skew for long cable runs.