Setup guide

3
4
Unit Layout & Description
1) Power LED
a. LED will be active when unit is powered on
2) Video/Audio Input
a. Connect to VGA source (TV, Monitor, Projector, etc) using a VGA 15 pin Male to Male cable for video and
3.5mm Stereo Male to Male cable for audio.
3) Video/Audio Out
a. Connect to VGA display (TV, Monitor, Projector, etc) using a VGA 15 pin Male to Male cable for video
and 3.5mm Stereo Male to Male cable for audio.
4) Cat5e/6 Output
 a. ConnecttotheCat5e/6(UTP)inputontheReceiverunit.
5) DC/5V Connector
a. Connect the 5V Switch Splitter power supply to this port
Transmitter
Front
Po
wer
Output 4 Output 3 Output 2 Output 1
InputPower
GAIN
PEAK
VGA Input VGA Output
VGA Output
Po
wer
Output 4 Output 3 Output 2 Output 1
InputPower
GAIN
PEAK
VGA Input VGA Output
VGA Output
Back
2
3
1
4
5
Receiver
Output
Input
Power
GAIN
PEAK
VGA Input
VGA Output
VGA Output
Output
InputPower
GAIN
PEAK
VGA Input
VGA Output
VGA Output
Back
Front
1) Video/Audio Output
a. Connect to VGA display (TV, Monitor, Projector, etc) using a VGA 15 pin Male to Male cable for video
and 3.5mm Stereo Male to Male cable for audio.
2) Power LED
a. LED will be active when unit is powered on
3) Cat5e/6(UTP)input
a. Connect to the Cat5e/6 output on the Transmitter
4) DC/5V Connector
a. Connect the 5V Switch Splitter power supply to this port
5) Gain
 a. Rotarydialusedforadjustingthebrightnessonthedisplays
6) Peak
 a. Rotarydialusedforadjustingtheskewforlongcableruns
3
4
1
2
Output
InputPower
GAIN
PEAK
VGA Input
VGA Output
VGA Output
Side
5
6