Manual

23
◆Forwarding data format
(1) Repeat, Single, Continuous mode
Format Byte Explanation
999 crlf 5 Store No
9 crlf 3
Measurement mode (1：Repeat、2：Single、3：Continuous）
99,99,99 crlf 10 Measurement start date
99,99,99 crlf 10 Measurement start time
99,99,99 crlf 10
Sampling time（hours, minutes, seconds）
xxx crlf 5
Particle unit （ CNT , /cf , /m
3
）
x crlf 4
Temperature unit （ C , F ）
xxx crlf 5
Air velocity unit （ m/s , FPM ）
x,x,x crlf 7
Error message
(L：Light source, F：Flow rate, O：Over the maximum concentration)
999999999 crlf 11 Count data of 0.3µm, 90999E+99crlf using /cf or /m
3
as unit
999999999 crlf 11 Count data of 0.5µm, 90999E+99crlf using /cf or /m
3
as unit
999999999 crlf 11 Count data of 1µm, 90999E+99crlf using /cf or /m
3
as unit
999999999 crlf 11 Count data of 3µm, 90999E+99crlf using /cf or /m
3
as unit
999999999 crlf 11 Count data of 5µm, 90999E+99crlf using /cf or /m
3
as unit
＊999.9 crlf
7 Temperature data
＊999.9 crlf
7 Humidity data
＊9.999 crlf
7 Air velocity data, 999.9 crlf using FPT as unit
Total 135
＊）・T./H or Air velocity probe is not selected it becomes “ ***** crlf”.
・It becomes “###.#” when the value of T/H probe exceeds measurement range.
・ It becomes “###.#” using m/s as unit (when the value of Air velocity probe exceeds measurement
range.)
Using FRM as unit, it becomes “###. #”.