User guide

23
<Setting the CALCULATION MODE>
Select “1. MODE“ and press .
Use to select AVERAGE or
INSTANT and press .
<Setting the SAMPLING TIME>
Use to select
“2. SAMPLING (TIME)” and press .
Use to select SAMPLING TIME
(1 to 999 sec) and press .
<Setting the No. TRIAL (N)>
Use to select “3. SAMPLING(n)”
and press .
Use to select No. TRIAL
(1 to 9999 times) and press .
Data obtained by the number of trials
set here will be stored.
<DATA STORAGE>
Use to select
“4. DATA STORAGE?” and press .
Use to select YES or NO and
press .
There must be sufficient memory to store the calculation data. If the
measured data would exceed the available number of empty data
locations, Climomaster will automatically adjust the number of trials to
match the amount of free remaining memory locations. (Ex.: if there is
R0020/20000 remaining, you can only measure 20 times even if you
set the No. TRIAL to more than 20.
<Save the Settings>
Use to select
“5. SET TO START” and press .
(In the example shown at the left, the
instrument will perform fifty (50)
measurements of one (1) second
intervals.)
CALCULATE R20000/20000
1.MODE11111111AVERAGE
2.SAMPLING(TIME)0012s
3.SAMPLING(n)110050
4.DATA2STORAGE2?22YES
5.SET2TO2START
CALCULATE R20000/20000
1.MODE11111111AVERAGE
2.SAMPLING(TIME)0012s
3.SAMPLING(n)110050
4.DATA2STORAGE2?22YES
5.SET2TO2START
CALCULATE R20000/20000
1.MODE11111111AVERAGE
2.SAMPLING(TIME)0012s
3.SAMPLING(n)110050
4.DATA2STORAGE2?22YES
5.SET2TO2START
CALCULATE R20000/20000
1.MODE11111111AVERAGE
2.SAMPLING(TIME)0012s
3.SAMPLING(n)110050
4.DATA2STORAGE2?22YES
5.SET2TO2START
CALCULATE R20000/20000
1.MODE11111111AVERAGE
2.SAMPLING(TIME)0012s
3.SAMPLING(n)110050
4.DATA2STORAGE2?22YES
5.SET2TO2START