Use and Care Manual

ManualsBrandsKANTE ManualsFire Pits25 in. W x 13.4 in. H Outdoor Round Concrete Metal Propane Gas Fire Pit Table in Charcoal with Tank Cover Storage Box

BOWL CONCRETE FIRE PIT TABLE

ASSEMBLY AND CARE INSTRUCTIONS

WARNING

1.When Fire Pit is not in use — disconnect Propane Tank.

2.If Fire Pit is stored indoors — remove Propane Tank.

3.INSTALLER: Leave this manual with the appliance.

4.CONSUMER: Retain this manual for future reference.

WARNING

1.Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other

appliance.

2.An LP-cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.

3.This Fire Pit must be attended at all times!

4.USE PROPANE GAS ONLY.

5.For use with tanks marked PROPANE only.

6.DO NOT connect to a remote gas supply.

WARNING

FIRE OR EXPLOSION HAZARD

If you smell gas:

1.Shut off gas to the appliance.

2.Extinguish any open flame.

3.If odor continues, leave the area immediately.

4.After leaving the area, call your gas supplier or fire department. Failure to follow these instructions

could result in fire or explosion, which could cause property damage, personal injury, or death.

WARNING

If the information in this manual is not followed exactly, a fire or explosion may result causing property

damage,personal injury, or loss of life.

WARNING

FOR OUTDOOR USE ONLY!

Installation and service must be performed by a qualified installer, service agency, or the gas supplier.

Summary of content (6 pages)

PAGE 1
BOWL CONCRETE FIRE PIT TABLE ASSEMBLY AND CARE INSTRUCTIONS WARNING 1.When Fire Pit is not in use — disconnect Propane Tank. 2.If Fire Pit is stored indoors — remove Propane Tank. 3.INSTALLER: Leave this manual with the appliance. 4.CONSUMER: Retain this manual for future reference. WARNING 1.Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. 2.
PAGE 2
DANGER AND WARNINGS CARBON MONOXIDE HAZARD This appliance can produce carbon monoxide which has no odor. Using it in an enclosed space can kill you. Never use this appliance in an enclosed space such as camper, tent, car or home. Read and follow all instructions and warnings in this Owner’s Manual thoroughly before installing, operating, or servicing this Fire Pit.
PAGE 3
DANGER AND WARNINGS Observe flame color and flame height after the Fire Pit is ignited: 1) Flame color should be yellow. 2) Flame height burns at 2 - 10 inches high. THIS PRODUCT USES PROPANE ONLY • Use propane cylinders with the following required measurements only: 30.5 cm/12 in (diameter) x 45.7 cm/18 in (tall) with capacity 9 kg/19.84 lbs.) • Max gas supply 28cm/11 in w.c. (2.74kpa) • Only cylinder marked "propane” may be used.
PAGE 4
ASSEMBLY INSTRUCTIONS 1. Check that the control knob for the gas supply system is turned to the “OFF” position before starting any assembly. 2.Turn the cylinder valve on the tank clockwise to close the propane tank. Attach the preassembled regulator from the body to the cylinder valve by turning the regulator coupling nut clockwise. Make sure it is fastened securely and tighten connections by hand only. 3.
PAGE 5
OPERATION Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “off”position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles occur on any connection there may be a leak.If you smell gas or a leak is discovered turn thegas valve off, disconnect propane gas tank and do not use the appliance until the leak is repaired.
PAGE 6
TROUBLESHOOTING Problem Heating unit won’t light Burner won’t light while using a match Heating unit emits a lot of black smoke Sudden drop in gas flow Flame blows out easily Cause Solution Igniter pin and burner are wet Dry off with a soft cloth Igniter battery is incorrectly inserted Igniter pin is broken Check which direction the battery is inserted Electrode wire is loose or disconnected Electrode wire is shorting between valve and igniter pin No gas flow Reconnect wire to the igniter box l