Manual

14
RESET
LED
RESET
LED
Special Functions
Automatic Power Up (APU) / Automatic Power Down (APD)
TUK is designed to save power when not in use. When no audio signal has been detected for 15
minutes, TUK will put itself into standby mode (APD). If the audio signal returns via the same input
that TUK was playing when it entered standby, TUK will wake up and resume playing (APU). It can
also be woken up manually by:
• Pressing the Standby Button on the Remote
• Pressing the Control knob
If you do not nd the APU feature useful, you can disable it by pressing the
Treble Reset button on the remote and holding it for 5 seconds. The Input LED
will blink once to indicate that you have disabled the APU feature. To enable
APU if you have disabled it, simply press and hold the Treble Reset button again
for 5 seconds. The Input LED will blink twice to indicate that you have enabled
APU.
If you do not nd the APD feature useful, you can disable it by pressing the Bass
Reset button on the remote and holding it for 5 seconds. The Input LED will
blink once to indicate that you have disabled the APD feature. To enable APD if
you have disabled it, simply press and hold the Bass Reset button again for 5
seconds. The Input LED will blink twice to indicate that you have enabled APD.
ATTENTION
APU / APD is always enabled by default. APU will only activate after APD has been triggered. APU
will not work if the unit is manually switched to standby using the remote or control knob.
Bass / Treble Memory (BTM)
By default, TUK applies your EQ (bass & treble) settings to all inputs. If you
prefer to set individual EQ settings for each input, you can activate Bass Treble
Memory (BTM) by pressing and holding the Play / Pause button for 5 seconds.
The Input LED will blink twice to indicate that BTM has been activated. You can
deactivate BTM by pressing and holding the Play / Pause button for 5 seconds.
The Input LED will blink once to indicate that BTM has been deactivated. BTM is
disabled by default and by Factory Reset.
Factory Reset
All settings on TUK can be reverted to factory default by switching the Power
Switch to the OFF position, waiting 5 seconds, then switching back to the ON
position.
LED Brightness
TUK's Input LEDs on the front panel can be adjusted to 5 brightness levels
including o. Cycle through the brightness settings by pressing the LED button
on the TUK remote. LED brightness can also be adjusted while TUK is in
standby mode.