Installation Instructions

ManualsBrandsKaonbroadband ManualsComputers & AccessoriesGPON Gateway

Table Of Contents

PG2141 Quick Installation Guide

Quick InstallationGuide

PG2141 is GPON ONT for FTTH Networks BoSA On Board Optical

Solution Smart Wi-Fi.

1. Front Panel

PG2141 Quick Installation Guide

LAN 1-4

Off Internet service isnot available.

Flashing The modem isinitializing.

On Internet service isavailable.

LOS

Off

Flashing The modem is upstream ranging.

On The modem is upstream locked.

PON

Off The initialization is not started, or has failed.

Flashing The PON mode is scanning the range.

On The PON mode is available.

POWER

Off The modem is powered off.

On The modem is powered on.

Connect the Hardware

If your Internet connection is through an Ethernet cable from the

wall instead of through a DSL/Cable modem, connect the Ethernet

cable directly to the router’s Internet port, and skip Step 1,2,3 to

complete the hardware connection

The modem is upstream ranging.

Summary of content (5 pages)

PAGE 1
. Front Panel 1 2 3 4 5 6 Quick Installation Guide PG2141 is GPON ONT for FTTH Networks BoSA On Board Optical Solution Smart Wi-Fi. Connect the Hardware If your Internet connection is through an Ethernet cable from the wall instead of through a DSL/Cable modem, connect the Ethernet cable directly to the router’s Internet port, and skip Step 1,2,3 to complete the hardware connection. 1 POWER 2 PON 3 LOS 4 LAN 1-4 Off The modem is powered off. On The modem is powered on.
PAGE 2
Off Flashing 5G WiFi is sending or receiving data. 5 5G 8 On 5G WiFi Interface enabled. Off 2.4G WiFi Interface disabled. Flashing 2.4G WiFi is sending or receiving data. 6 2.4G 7 3. Rear Panel 5G WiFi Interface disabled. WPS On 2.4G WiFi Interface enabled. Off The WPS Interface enabled. 1 Flashing The WPS Interface in use. PHONE1-2 On The LAN port is connected. Off The telephony service isnot available. 2 Flashing The telephony line is in use.
PAGE 3
5. Instruction for Connecting Modem – PC 4. Connecting and Installing devices Before installation, please check with your service provider to ensure that the cable broadband is active. 1) Make sure the following: - Your Cable Modem is powered ON. The power LED will be turned ON. - Your PC is turned-on and connected to Cable Modem using an Ethernet cable. - Connect tightly the coaxial cable to the cable outlet. - After Online LED is ON, Cable Modem becomes online.
PAGE 4
Exterior Design Specification MainChipset GPON BCM68460 Memory 128MB NAND Flash 256MB DDR3 RAM Wi-Fi 802.11 a/b/g/n/ac MU-MIMO 3x3 2.4 GHz + 4x4 5 GHz dual band concurrent Internal antenna Mesh KAON Smart Mesh Front 12 x LED Indicators WPS Button PG21241 Specification Quick Installation Guide Rear 1 x Fiber optic 4 x GbE LAN Ports 2 x FXS ports (RJ-11) 1 x USB2.0 1 x Power switch, Pin-hole reset button Power DC 12V(2.
PAGE 5
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.