User's Manual

1) WAN IF Settings

You can set the WAN interface information.

1-1) WAN Service

A user can choose either “IP over Ethernet” or “Bridging” mode. When the user select “IP over Ethernet”, the user can

manually congure the rest of the menu below. When the user select “Bridging”, 802.1 P priority get set to “-1” and

802.1Q LAN ID get set to “-1” and all other parameters below become deactivated

1-2) Protocol

A user can select IPv4 Only , IPv4 & IPv6 (dual stack), or IPv6 only

1-3) WAN IF Setting

A user can select either one of the following mode; “User the following static IP address” or “obtain an IP address

automatically”

2) NAT

A user can enable or disable NAT (Network Address Translation) function.

3) Firewall Settings

You can set the Firewall information.

3-1) IPv4 Firewall Protection

User can enable or disable the basic rewall functions.

4) Interface

It shows the interface information like Wi-Fi interface or Ethernet interface

5) Description

It shows which authentication method is used e.g. IPoE or PPPoE

6) IGMP Proxy

It shows whether IGMP Proxy is enabled or disabled

7) NAT

It shows whether NAT is enabled or disabled

In this page, you can congure IPoE for WAN service connection.

8.1.1 WAN Service - IPoE

4 5 6 7 8 9 10 11

1-1

3-1

1-2

1-3