User's Manual

USER MANUAL: T500 Tag Programming Station (TPS) Document A316000-699

3.0 Program installation procedure

You must be an “Installer” to perform this function.

Make a copy of the original program disk(s). Store the original disk(s). Use the copy to install the program onto

your hard drive. The TPS program is entirely self-installing by using the "Setup.exe" utility on program disk #1.

Be prepared to use the secret “installer's password” and the “authorization code" at the appropriate prompt in

the install process.

• Verify that there are no other Windows® applications currently running on the computer

(i.e. Word®, Excel®, etc.)

• Insert program disk #1 into the floppy drive.

• Use the Windows® toolbar commands "Start", "Run" then "Browse" to locate the Setup program (see

example below).

• Click "Open", the Run window is displayed again except now the Setup.exe utility is loaded.

• After clicking "OK", the very first message box for the TPS install will look like this…

There are several screens associated with the InstallShield

Wizard displayed next.

The InstallShield

Wizard is

installed first and you are prompted

to wait.

Important Note:

It is not necessary to have the TPU

connected in order to install the software

and configure the system users.