Manualshelf

User's Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsT500 Tag Programming Station
21222324252627282930
USER MANUAL: T500 Tag Programming Station (TPS) Document A316000-699
©1999-2008 MARK IV INDUSTRIES CORP. I.V.H.S. DIVISION pg. 28 of 69
continued…
• After verifying that the fixed Agency fields are correct you must then verify that the 31 bits of custom
Agency Data are set to the desired value.
• Click on the Agency Custom folder tab to view the current value set for this field.
• After verifying that the 31 bits of fixed custom Agency Data are correct you must then verify that the 30 bits
of custom Scratch Pad Data are set to the desired value.
• Click on the Scratch Pad Custom folder tab to view the current value set for this field.
• Click on the Scratch Pad folder tab to view the current value set for "Clear Unassigned Bits".
At this point the data to be programmed has been visually verified. The tag may now be programmed. Refer to
the section Program an IAG Tag.
The default value is 31 zeros (as shown). This
portion of the Template file is created and stored in
a separate directory as specified by a Supervisor. If
the required agency custom data file does not exist
then only a Supervisor may design a new agency
custom data file.
The default value is 30 zeros (as shown).
This portion of the Template file is created
and stored in a separate directory as
specified by a Supervisor.
If the required scratch pad custom data file
does not exist then only a Supervisor may
design a new scratch pad custom data file.
Values that were pre-assigned by a
Supervisor are shown in selection boxes.
"Clear Unassigned Bits", when selected, will set
all the unused bits in the entire field to zero. If no
template is loaded the default is "unselected".
"Clear Unassigned Bits", when selected, will set
all the unused bits in the entire field to zero. If
no template is loaded the default is "selected".
"Clear Traffic Management Data", when selected,
will set all the unused bits in the entire field to zero.
If no template is loaded the default is "selected".
"Clear Toll Collection Data", when selected, will set
all the unused bits in the entire field to zero.
If no template is loaded the default is "selected".