User's Manual

USER MANUAL: T500 Tag Programming Station (TPS) Document A316000-699
©1999-2008 MARK IV INDUSTRIES CORP. I.V.H.S. DIVISION pg. 29 of 69
4.4.3 Program an IAG tag
• Load and verify the required "template" file for programming the tag. Refer to the section titled Load a
Template.
• Place the tag to be programmed into the foam insert in AU drawer
2
. Close the AU drawer.
• If the Supervisor (see Supervisor Configuration of Automation parameters) has set the Automatic Write
function, the tag will be programmed. Within 1 second the "Write Successful" message is displayed (as
shown further below).
• If the Automatic Write function has not been set, click on the Program button.
• Within 1 second the "Write Successful" message is displayed.
Message "Write Failed"
The following message appears whenever the tag cannot be programmed.
2
There are two drawer configurations, see Appendix - Positions of tags in the AU drawer "cradle". The cutout in the foam "cradle"
allows for several different tag configurations to be used. The tag orientation is shown in a specific photo appendix to this document,
example: IAG FPT tag orientation in the AU drawer. More photos of the AU drawer depicting various tag orientations along with
different foam inserts will be added as the TPS system is expanded to handle other tags.
Click on "Details" to view more report data.
A
n exam
p
le of more data is shown at ri
g
ht.
Reason for failure