User's Manual

USER MANUAL: T500 Tag Programming Station (TPS) Document A316000-699

MANUAL REVISIONS

The complete revision detail list is found in Appendix-Document Revision Control.

FCC/Industrial Canada Warnings

* This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

– Reorient or relocate the receiving antenna

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

– Consult the equipment manufacture for help.

* Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

* The transmitter and antenna must not be co-located or operating in conjunction with any other

antenna or transmitter. Failure to observe this warning could produce an RF exposure condition.

* The operation of this device is subject to the following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference, including interference that

may cause undesired operation of the device.

* This device has been designed to operate with the antenna unit included in the system. Use of

any antenna device other than the one included is strictly prohibited.