User's Manual

USER MANUAL: T500 Tag Programming Station (TPS) Document A316000-699

1.3 Tag "cradle" inside the AU drawer

The tag cradle is shown at right in a "top view" photo (of the AU

drawer pulled out). The cradle shown in the photo at right is

configured to accept various Fusion or Type 2 LCD tags. A

separate AU drawer

has a cradle that is configured to accept

various FPT, RMT or LPT tags.

Drawers are easily exchanged by slipping them on and off from

the drawer glides as shown in the photo below.

Lift up on the black plastic locks on

both sides of the drawer while gently

pulling the drawer up and out from the

slides.

Reverse the procedure to install a

drawer. Pull the slides out frontward

as far as possible to re-engage the

locks. Both locks must "click" into

place.

IMPORTANT…

The correct alignment of the tag in the cradle is vital to the programming process. When placing any tag into

the cradle, ensure that the applicable alignment diagram (or photograph) is referenced. For details, refer to

Appendix - Positions of tags in the AU drawer "cradle".

This feature will be changed to a single drawer for all tags. Refer to the notes on page 2 of Appendix - Hardware.