User's Manual

Optional FME location: front bumper
1. Apply one side of five 3M™ Dual Lock™ fasteners to the FME.
a) Using rubbing alcohol, clean the rear surface of the
transponder to ensure the bonding surface is free of dirt and
any surface contaminants.
b) Allow the rear surface of the transponder to dry completely.
c) Cut the Dual Lock™ fastener into five 1½ in. lengths.
d) Remove the protective backing from one side the five Dual
Lock™ fasteners and apply the fasteners equally spaced on
the rear of the transponder.
©Kapsch TrafficCom IVHS. All rights reserved Subject to alteration without notice.
Dual Lock™ fasteners
FME Mounted on Bumper
2. Select the transponder mounting location on the front bumper at the
center of the vehicle (as measured from the right and left sides of the
vehicle), 15 to 21 in. from the top of the transponder to the road
surface.
3. Using rubbing alcohol, clean the mounting location on the bumper.
Allow the mounting location to dry completely.
4. Remove the remaining protective backing from the five Dual Lock™
fasteners and press the transponder onto the mounting location on the
bumper, ensuring the orientation arrows are pointing skyward.
Maintain pressure for 15 seconds to ensure a good bond.
5. Remove the transponder by lifting any corner with sufficient force to
separate the Dual Lock™ strips. Do not reuse the Dual Lock™ strips
after removing them from the bumper. Obtain new strips as required.
Kapsch Group
The Kapsch Group and its entities Kapsch TrafficCom, Kapsch CarrierCom and Kapsch BusinessCom are specialized in the future-oriented market
segments of Intelligent Transportation Systems (ITS) and Information and Communication Technologies (ICT). Kapsch. Always one step ahead.
801850-017 rev A.
Kapsch TrafficCom IVHS | 6020 Ambler Drive | Mississauga, Ontario L4W 2P1 | CANADA | Phone [phone] | Fax [phone]
54 S. Commerce Way, Suite 100 | Bethlehem, PA 18017 | USA | Phone [phone] | Fax [phone]
E-Mail [e-mail] | [e-mail] | www.kapsch.net
centerline of vehicle
road surface
15 to 21 in.
front bumper
FME Rear View