Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Operating Instructions
Confidential UM 360463-202: A12 (Draft) Page 108 of 291
© Kapsch TrafficCom Canada Inc. 2014
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict confidence and will be kept confidential and used solely for the purpose
intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24
Kapsch TrafficCom
Command
How is this command
executed?
Who can
execute this
command?
Parameter
Name
Default
Parameter
Value
Parameter
Range/Options
What does this
command do?
What is the
purpose of this
command?
MPR RF
Protocol
This command is unavailable to
users and is set by Kapsch
TrafficCom personnel
Kapsch
TrafficCom
personnel
MPR_RF
0 (ISO-6B)
0 (ISO-6B)
1 (ISO-6C)
2 (ATA)
3 (ISO-6B/ATA)
Sets the MPR RF protocol
for each MRFM channel
to set the MRFM
to ISO-6B, ISO-
6C, ATA, or ISO-
6B/ATA
Note: the MRFM
hardware must
also be
configured when
selecting the 6C
protocol.
MPR Frequency
This command is unavailable to
users and is set by Kapsch
TrafficCom personnel
Kapsch
TrafficCom
personnel
MPRFRQ
0 (903.25)
0 (903.25)
1 (912.25)
2 (915.25)
3 (918.25)
sets the MPR Frequency
for each MRFM channel
to set the MPR
frequency to
903.12, 912.25,
915.25, or
918.25
Channel tab
TDM Enable
From the Channel tab on the
Configuration page:
Select the TDM Enable
checkbox.
anyone
TDMEBL
0 (Disabled)
0 (Disabled)
1 (Enabled)
Disabled: TDM selections
not available to configure.
Enabled: TDM selections
available for
configuration.
Enables TDM RF
scanning.
Note: At least
one of 'TDM
Enable' or 'FDM
Enable’ must be
enabled at all
times.