Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Operating Instructions
Confidential UM 360463-202: A12 (Draft) Page 109 of 291
© Kapsch TrafficCom Canada Inc. 2014
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict confidence and will be kept confidential and used solely for the purpose
intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24
Kapsch TrafficCom
Command
How is this command
executed?
Who can
execute this
command?
Parameter
Name
Default
Parameter
Value
Parameter
Range/Options
What does this
command do?
What is the
purpose of this
command?
TDM RF State
From the Channel tab on the
Configuration page:
Select one of the choices
offered from the drop down
menu for every appropriate
channel.
anyone
RF_STS
0 (Offline)
0 (Offline)
1 Active
2 Guard
3 Skip
Offline means the MRFM-
S module is off.
Active means the MRFM-S
module is on and reports
transactions on this channel.
Guard means MRFM-S
module is on, but
transactions assigned to
this channel are not
reported.
Skip controls the scanning
rate and should be used
only for channels 5 or
higher.
Used for IAG,
Allegro
protocols,
TDM Tag
Protocol
From the Channel tab on the
Configuration page:
Select one or both of the
checkboxes for every
appropriate channel.
anyone
TDMPRT
0
0-3
Specifies which TDM
protocols are to be
interrogated per channel.
Select any or none of the
following by adding selected
values together:
0x00000001 - IAG
0x00000002 - Allegro
Used for IAG,
Allegro
protocols,