Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Operating Instructions
Confidential UM 360463-202: A12 (Draft) Page 119 of 291
© Kapsch TrafficCom Canada Inc. 2014
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict confidence and will be kept confidential and used solely for the purpose
intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24
Kapsch TrafficCom
Command
How is this command
executed?
Who can
execute this
command?
Parameter
Name
Default
Parameter
Value
Parameter
Range/Options
What does this
command do?
What is the
purpose of this
command?
Heartbeat
Interval
From the LC tab on the
Configuration page:
With heartbeat messages
enabled, enter a time, in
seconds, in the Heartbeat
Interval check box, then, press
Enter or select a different tab.
anyone
LCHBTM
2
1-30
sets the heartbeat
message interval
to configure how
often heartbeat
messages are
sent from the
Reader to the LC
Destination
From the LC tab on the
Configuration page:
Select the Serial and/or
Ethernet check box for each RF
channel and then press Enter
or select a different tab..
anyone
LCDEST
0 (Serial)
0 (Serial)
1 (Ethernet)
Serial: sets channel to
communicate with the LC
by a serial connection
Ethernet: sets channel to
communicate with the LC
by an Ethernet connection
sets how
individual RF
channels
communicate
with the LC
Serial Port
From the LC tab on the
Configuration page:
With serial communications
enabled, select the appropriate
LPM COM Port from the Serial
Port drop-down box and then
press Enter or select a different
tab..
anyone
LCSERL
0 (COM 1)
0 (COM 1)
1 (COM 2)
2 (COM 3)
3 (COM 4)
4 (COM 5)
5 (COM 6)
6 (COM 7)
7 (COM 8)
assigns an LPM COM Port
to each MRFM-S channel
to configure
which LPM COM
Port sends data
for a specific
MRFM-S channel