Operations and Maintenance Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNon-multilateration LMS transmitter and receiver

171

172

173

174

175

176

177

178

179

180

JANUS

Multi-Protocol Reader Ver. 2: Maintenance Instructions

Confidential UM 360463-202: A12 (Draft) Page 178 of 291

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24

Kapsch TrafficCom

3. Select Badger-Style CRA from the Communication Method drop-down box.

Result: The following screen appears.

4. Configure how multiple transactions are reported to the LC:

 To send one transaction report per OBU to the LC without informing the LC of suppressed reports,

select Disabled from the Cross-Reader Reporting drop-down box.

 To send on transaction report per OBU to the LC and also inform the LC of suppressed reports,

select Report Non-zero from the Cross-Reader Reporting drop-down box.

5. Configure Tag Programming (see OBU Programming on page 61) ensuring that:

 TMP and TCP are enabled

 the Plaza IDs of all Readers at the plaza match

 the Reader ID for each Reader is different

Note: Multiple group IDs are not supported across multiple Readers.

6. From the Channel tab on the Configuration page, ensure all channels covering one direction of traffic

have the same Group ID.

Note: The transponder timeout, set in the Group tab on the Configuration page, must be greater than the

time difference between all Reader clocks in the network.

7. Manually set the Reader clocks to within 2 seconds of the same time (refer to the Manually setting the

Reader time and date procedure on page 255).

Selecting the Voting Algorithm

Prerequisites: Connect the service laptop to the Reader configuration port to access the CTM web

interface. Refer to Connecting a service laptop to the Reader, page 40.

Majority : The OBU is assigned to the channel with the most handshakes.

Interpolated: The Reader determines which set of three adjacent channels has the highest

handshake count. The OBU is then assigned to the channel within this set with the most handshakes.

1. Select the Configuration link on the left side panel.

Result: The following screen appears.