Operations and Maintenance Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNon-multilateration LMS transmitter and receiver

171

172

173

174

175

176

177

178

179

180

JANUS

Multi-Protocol Reader Ver. 2: Maintenance Instructions

Confidential UM 360463-202: A12 (Draft) Page 180 of 291

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24

Kapsch TrafficCom

2. Select either Majority or Interpolated from the drop-down box of the required protocol located in the

Lane Assignment Algorithm box.

Note: If Interpolated is selected from the drop-down box, channels with handshake counts that differ less

than the Handshake Equalization Ratio will be considered to have an equal handshake count since the

difference is not considered significant.

3. If Interpolated was selected in step 1, enter a percentage in the Handshake Equalization Ratio field.

4. Press Enter to accept the selections.

Configuring Voting Time

Manually setting a voting time gives a fixed voting time to each channel. Dynamic voting time allows

the Reader to calculate and base the voting time on the average capture zone span time (the time it

takes for an OBU to pass through a capture zone).

Manually set the voting time for a channel

Prerequisites: Connect the service laptop to the Reader configuration port to access the CTM web

interface. Refer to Connecting a service laptop to the Reader, page 40.

1. Select the Configuration link on the left side panel.

Result: The following screen appears.