Operations and Maintenance Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNon-multilateration LMS transmitter and receiver

201

202

203

204

205

206

207

208

209

210

JANUS

Multi-Protocol Reader Ver. 2: Maintenance Instructions

Confidential UM 360463-202: A12 (Draft) Page 206 of 291

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24

Kapsch TrafficCom

2. Connect the appropriate loop-back connector to the COM port. In the RS-232 loop-back connector, the Tx

and Rx signals are connected. In the RS-422 loop-back connector, the Tx+ and Rx+ signals are

connected and the Tx- and Rx- signals are connected. The LPM RS-232 pin outs are shown on page

268; the LPM RS-422 pin outs are shown on page 269.

3. Select the Diagnostics link on the left side panel of the CTM web interface.

Result: The following screen appears.

4. Select the Serial port loop-back test link.

Result: The following screen appears.