Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Maintenance Instructions
Confidential UM 360463-202: A12 (Draft) Page 222 of 291
© Kapsch TrafficCom Canada Inc. 2013
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict
confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or
used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24
Kapsch TrafficCom
3. Set the RF State of the MRFM-S whose cable or connector is being replaced to Offline.
4. Press Enter.
5. Remove the RF cables or connectors.
Installing an RF cable/connector
Prerequisites: Self-amalgamating tape for connections. Connect the service laptop to the Reader
configuration port to access the CTM web interface. Refer to Connecting a service laptop to the
Reader, page 40.
1. Install the RF cables or connectors.
2. Apply new self-amalgamating tape to the connections.
3. Select the Configuration link on the left side panel of the CTM web interface.
Result: The following screen appears.